Topic: Need Help.... USB -> RS232 adapter

The content of this topic has been archived on 30 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

RazorJack

29 Sep 2005, 04:15

I purchased a PL2032 chipset USB to RS232 DB9M adapter today. It was dirt simple to pull apart, and attempt to mod it so I can have a console port on my WRT54G. However, the console port does not work!

What PINS on the Linksys Board are Ground, RX and TX?

I have attached RX to 4, and TX to 6. On the Adapter the Ribbon cable attaches to the DB9M plug on the PCB side to Pin 2 RX and Pin 3 TX. Is this correct?

--Ian.

The discussion might have continued from here.

Page 1 of 1