Hi,
do we have some news about the ticket opened?
I have the same problem as this post.....
Here my situation:
=========
MY box is SL2-141-i, i changed the board to RTA1025W_16 to flash it with OpenWrt (http://wiki.openwrt.org/toh/gigaset/sl2-141-i) and after that it seems OK.
But i need to create VLANs to use 1 ethernet physical port as WAN. No need to use anymore the ADSL telephone port. WLAN is OK.
Now, i was working a lot trying to create a correct /etc/config/network file (lots of docs in web), but everytime i cannot make vlan working.
Then i noticed in/proc/switch/eth0 dir:
--> vlan_enable=0 ??
--> xxx file (don't remember) says this is a adm6996 chip.... --> not sure if there are some drivers missing
--> robotswitch module is OK
Not sure how is the architecture of this platform, i mean, if the internal switch is on eth0 or eth1... btw, i have only eth0 in /proc.
==================
Thanks for some suggestions and any kind of helps!!!