Hello,

I am asking for help since I don’t know about Linux command line

how to setup rtpproxy?

Could someone give me step by step instructions please how to set it up?

I am doing this because behind the NAT I am having Tandberg video conferencing unit,
which is able to establish a session with other party trough H.323/Q931 protocol stack but I am missing Audio/Video.
Controll protocols are ok, but transport is not.
Problem persist since in one of the fields of RTP header, public source address should be encapsulated once again.

If you think that there might be a better solution from routers cpu load prospective, please advise.
I need some sort of nat helper to achieve nat traversal with H.323.
I also saw that there are a few sip proxies in repository, but I dont know
with wich one my router would keep being responsive, neither how to set it up without gui.

Could someone elaborate this for me please?

I emphasizing once again to take in consideration that I am a Linux knob.

Kind Regards.