OpenWrt Forum Archive

Topic: Luci and wireless setting

The content of this topic has been archived on 14 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
wkevils
6 Sep 2011, 17:24

Hi,
I have kamaikaze (8.09.2, r18961) and I have installed luci-admin-full
by opkg.
I enter the web interface, and I see vert few menus.
I have:
Network->wifi menu.
But there is nowhere there where I can set encryption method, encryption
password , etc.
I go to network->wifi and all I see is:

Wifi
    Here you can configure installed wifi devices.
    Networks
        Link ESSID BSSID Channel Protocol Mode Encr. Power Scan
           
               
This section contains no values yet
           
could it be because I should somehow activate the wireless driver before ?
any advice?

rgs,
Kevin

Post #2
smaver
15 Oct 2011, 12:58

Try creating a script that launches the wi fi card drivers firts and it should work fine.

(Last edited by smaver on 15 Oct 2011, 12:58)

The discussion might have continued from here.