hi,
i have recently bought a TP-LINK TL-WR941ND and i installed the openwrt firmware. i wasnt familiar with the interface and i think that i turned all the LAN ports to WAN, or something like that.Now i cannot acces the router.i would  appreciate if anyone can help me.

do the same http://wiki.openwrt.org/toh/tp-link/tl- … lsafe.mode
don't forget to set you lan to static 192.168.1.10 or anything different that .1

(Last edited by maurer on 13 Oct 2011, 09:38)

Power up your router. When the 'SYS' light starts to blink, press and hold the 'QSS' button in the front-right until the blinking gets faster- this command is ok but i cannot telnet to the router.i am not sure if i have set right the static ip. i used this settings:
ip address:192.168.1.200
Default Gateway:192.168.1.10

Do i have to set somethinh for dns or just leave it blank??

(Last edited by michalis888 on 13 Oct 2011, 10:03)

gateway blank, DNS blank

Again i cant telnet to the router

(Last edited by michalis888 on 13 Oct 2011, 10:18)

is your subnet mask set to 255.255.255.0 ?

post your lan configuration

(Last edited by maurer on 13 Oct 2011, 10:43)

yes,
ip:192.168.1.10
subnet:255.255.255.0
and im trying to telnet to 192.168.1.1 using putty

When the 'SYS' light starts to blink, press and hold the 'QSS' button in the front-right until the blinking gets faster"
only then connect the lan cable and try to telnet

Nothing happens...I cant telnetn into the router...the 192.168.1.1 is standard???if i changed it from 192.168.1.1 to 192.168.1.2 for example, do i have to use the new one??

yes, try .2, but it should respond to .1 - very strange!
if it's not responding you'll need to recover it by serial console - http://wiki.openwrt.org/toh/tp-link/tl-wr941nd#serial

ok thnx for your time