OpenWrt Forum Archive

Topic: TP-Link TL-WR1043ND VLAN Tagging

The content of this topic has been archived on 21 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hi,

just bought a new router and tried DD-WRT until I found out they don't support Vlan Tagging for this router. So I installed OpenWrt and was happy to see some VLAN options in the settings. But whatever I tried, it didn't work.

OpenWrt: Backfire 10.03RC5 ( openwrt-ar71xx-tl-wr1043nd-v1-squashfs-factory.bin )

I am connection via VDSL Model and my WAN port needs to be tagged with VLAN ID 10

This is my network config so far:

config 'interface' 'loopback'
        option 'ifname' 'lo'
        option 'proto' 'static'
        option 'ipaddr' '127.0.0.1'
        option 'netmask' '255.0.0.0'

config 'interface' 'lan'
        option 'ifname' 'eth0.1'
        option 'type' 'bridge'
        option 'proto' 'static'
        option 'ipaddr' '192.168.1.1'
        option 'netmask' '255.255.0.0'

config 'interface' 'wan'
        option 'ifname' 'eth0.10'
        option 'proto' 'pppoe'
        option 'username' xxx@xxx.de'
        option 'password' 'xxx'

config 'switch'
        option 'name' 'rtl8366rb'
        option 'reset' '1'
        option 'enable_vlan' '1'

config 'switch_vlan'
        option 'device' 'rtl8366rb'
        option 'vlan' '1'
        option 'ports' '1 2 3 4 5t'

config 'switch_vlan'
        option 'device' 'rtl8366rb'
        option 'vlan' '10'
        option 'ports' '0t 5t'

But I always get the message that it cannot complete PPPoE discovery.

I suppose something is wrong with my config, as the modem works with the old router (from ISP, no WRT).

Thank you in advance.

Hm, no one?^^

I did, the config is basically from this thread. I just changed VID 7 to VID 10.

Just to complete this thread: Installed RC 6 and everything is working there (using the same config), so I guess something has been fixed along the way to RC6.

The discussion might have continued from here.