OpenWrt Forum Archive

Topic: how to block lan connection

The content of this topic has been archived on 13 Feb 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
reset
30 Nov 2005, 01:41

hi,

how to block (drop) a network comunication betweend eth0 and eth2 ? (it's bridged together)
I still try to find any solution, but everywhere is just WAN and LAN solution. Otherwise i'm eyeless.

I use a few wl500g connected throu WDS, all computers (40) are on same subnet, ethernet or wireless clients.
How to drop any connention?  (ip, ports, so on)

Please, help. Is it possible or not? How can I do that?

thx, regards

Post #2
dl
30 Nov 2005, 07:30
reset wrote:

how to block (drop) a network comunication betweend eth0 and eth2 ? (it's bridged together)

Break the bridge (unset lan_ifnames)?

- DL

(Last edited by dl on 30 Nov 2005, 07:33)

The discussion might have continued from here.