Since I can't write to the Tp-link factory image for MR11U (I wanted to disable hotplug script that runs the handle_card command) and debug..  I think Openwrt is the only way to go at this point, but there is no wiki for MR11u, I only found these 4 bin files below, can anyone explain what they are?

thanks

http://downloads.openwrt.org/snapshots/trunk/ar71xx/


openwrt-ar71xx-generic-tl-mr11u-v1-jffs2-factory.bin
openwrt-ar71xx-generic-tl-mr11u-v1-jffs2-sysupgrade.bin

openwrt-ar71xx-generic-tl-mr11u-v1-squashfs-factory.bin
openwrt-ar71xx-generic-tl-mr11u-v1-squashfs-sysupgrade.bin

Based on this

Sysupgrade.bin is for any router that is currently running either
openwrt or gargoyle and can be flashed via the GUI.

The factory.bin files are meant to be flashed over factory stock
firmware routers - they usually have some extra "magic bytes"
i.e. a trick header - to fool the factory firmware into thinking its
reading its own factory firmware, not 3rd party firmware.

I think I will use factory.bin, now jffs or squashfs...

(Last edited by kocoman on 14 Feb 2012, 18:07)