Hi,
I successfully built and installed OpenWRT [trunk] on my wndr3700v1. I am using it as an AP by connecting a LAN port to anther router on my home network. I recently found this <WNDR3700: bridging WAN and LAN ports> and this <Dumb AP>. I am wondering if by using this configuration:
(1) Keeping everything the same, I can use the WAN port to connect to the main router instead of a LAN port ?
(2) I'd have full four LAN ports ?
(3) And how do I access the router after the configuration is changed and (in case) the bridge does not work ?
Thanks.
Topic: wndr3700v1 - dumb AP mode
The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
1) Yes
2) Yes
3) Generic Failsafe - OpenWrt Wiki
Great. Thanks.
The discussion might have continued from here.
Page 1 of 1