et0mdcport=0 
et0phyaddr=30 
et1mdcport=1 
et1phyaddr=5 
lan_ifname=eth0 
lan_ifnames=vlan0 eth1 eth2 
lan_ipaddr=192.168.1.1 
lan_netmask=255.255.255.0 
lan_proto=static 
old_ifname=eth1 
old_ipaddr=192.168.33.99 
old_netmask=255.255.255.0 
old_proto=static 
vlan0hwname=et0 
vlan0ports=0 1 2 3 5u 
vlan1hwname=et0 
vlan1ports=4 5 
wan_device=vlan1 
wan_hostname=sl 
wan_ifname=eth2 
wan_proto=dhcp 
wl0_akm=none 
wl0_channel=1 
wl0_closed=0 
wl0_ifname=eth2 
wl0_infra=1 
wl0_mode=sta 
wl0_radio=1 
wl0_ssid=XXXXX
wl0_wep=disabled 
wl0gpio2=0 
wl0gpio3=0 
wl0id=0x4320

I run my "SL" in wireless client mode.  I have the switch set up to DHCP clients and the "OLD WAN" port set up as a static ip extra door.

Mike (mrdvt92)

Buffalo WVR-G54
CPU BCM4704 266Mhz  RAM 64M  Flash 8M  bcm4306 wlan
Mod 2 port USB 1.1  4 port usbhub

printer server,samba server,webcams spca5xx,

(Last edited by sjd2651 on 3 Nov 2006, 10:12)

I have a WRTSL54GS with a USB hard-drive attached.

The UsbStorageHowto page says "USB 2.0 support in Whiterussian is broken". I tried White Russian RC5 and that seemed to be true - i installed all the packages as instructed and only got slooowwww usb 1.1 speeds. This was unbearable so i went back to stock Linksys firmware.

Has this been fixed in RC6? When will I be able to use OpenWRT firmware on my WRTSL54GS and get USB2? I see one guy had 2.8mb/sec write speeds - how? with stock firmware? Or Whiterussian hacked somehow?

How are you timing the USB write performance? Have you timed USB reads?

I am using a WRTSL54GS with White Russian RC6 and a Kingston USB 2.0 flash ram stick, it seems fine but I haven't timed it.

(Last edited by JV on 21 Mar 2007, 03:59)