OpenWrt Forum Archive

Topic: WiFi Signal Power Update

The content of this topic has been archived on 25 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
Fado84
13 Apr 2012, 08:39

Hi folks!

To update the signal power of the Associated Stations (that i see with the command: iw dev wlan0 station dump ) I created a socket communication with the associated device.


Is there any other method without a socket communication??

thanks

Post #2
jow
13 Apr 2012, 09:28

You can try a ping or arp request instead.

Post #3
Fado84
13 Apr 2012, 13:40

Thanks jow!

I will try with a ping/arp in a loop every 500ms - 1s.. thanks!!!

The discussion might have continued from here.