OpenWrt Forum Archive

Topic: (TL-WR703n / GPIO / Misc) AR9331 pinouts?

The content of this topic has been archived between 7 Oct 2014 and 7 May 2018. Unfortunately there are posts – most likely complete pages – missing.

Sorry, posts 126 to 129 are missing from our archive.

Abdullbasit wrote:

Did you even read its datasheet ?:
www.openhacks.com/uploadsproductos/ar9331_datasheet.pdf

And ... what is your point?  Are you trying to bring our attention to some aspect of the chip not thus far addressed?  If so, could you be more explicit?

I wonder if anyone has gotten GPIO interrupt functionality working?  Looking at the datasheet, it seems this requires setting the right bits in the GPIO_INT_TYPE, GPIO_INT_POLARITY, GPIO_INT_MASK, GPIO_OE registers.  OK, but then how do I know what IRQ line the GPIO will trigger?  And are there any other registers I need to set?

The discussion might have continued from here.