JP1-2: Rx (input to router)
JP1-5: Tx (output from router)
JP1-6: GND
Topic: Netgear WNDR4000 serial port pinout
The content of this topic has been archived on 3 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
the wiki is the best place for this information. thx
Hmm, it's not working for me. Are you sure these are the correct ones? Could you provide us with a picture displaying the pinout? thanks
The discussion might have continued from here.
Page 1 of 1