OpenWrt Forum Archive

Topic: line 12 : can't open /lib/functions/network.sh

The content of this topic has been archived on 2 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Hi all, I have big problems with ddns to update my ip.
I tried with no-ip.com  dyndsn.org and FreeDNS.afraid.org and there is nothing to do.
I followed all the instruction of the DDNS Client guide in HOWTOs. Reinstalled packages and now after some attempt I can't use commands to update manually or check state of ipupdate (those ones on the guide) because I receive this message :  line 12 : can't open /lib/functions/network.sh

Tried to reboot but nothing!
Do you have a solutions please? Don't want to start over again with firmware installation sad
Thank you!

EDIT: The file doesn't exists!!!!!! O_O I'm sure I had it before!

EDIT2: Problem solved, after incredible discover of missing file I have sent it to the router and now it works correctly. If you had same issue you can find it here: https://dev.openwrt.org/browser/trunk/p … ?rev=31937

(Last edited by alexander_doni on 29 May 2012, 19:36)

I had the same problem.

Seems to have solved it by method described above but I needed to also do :

opkg install jshn

The discussion might have continued from here.