hi, i have installed this file http://downloads.openwrt.org/snapshots/ … actory.bin, it installed but i not know why i not can go to the home page to configure the ap

sorry for me english

pleas helpme

when i upgrade my acces point for the most recent openwrt firmware, i not can configure my acces point, before with this 192.168.1.254 i configured my acces point but now after upgrade my acces point i not can go to the homepage for configure my acces point

The file you flashed contains no web interface. Use telnet & ssh.

but i not can go to homepage for configure my acces point, i do not know how flash again my acces point because i not can acces in the homepage

Jow meant that you need to use command line interface with telnet (or ssh) to access the router and to install the "home page" GUI Luci using commands "opkg update" and "opkg install luci". Then you can access the "home page", by which I think you mean a graphical user interface for the router.
And the router's address is probably 192.168.1.1, (not 192.168.1.254).

(Last edited by hnyman on 15 Jun 2012, 16:01)

thankyou for answer but i'm new to this topic, practically i don't understand that is it "telnet" and "ssh", can you tell me step by step please?

I could install LUCI, but I had a problem accidentally delete the configuration with which I connected the AP,
the direction that had the ap was 192.168.1.250, but as clear as I can not go at all. how to install a new ip address?

how i install a new ip adress?? i deleted accidentally the ip adress via LUCI and now i can`t  enter via telnet and luci