sorry if this is so simple to answer
im so new to this and im lost
basicaly old router i want to put new softwhere on it from open wrt or realy love to turn it in to a WiFi Pineapple any way
usb ttl runing good
putty running good com and speed set
is there a dumb ass guide somewhere
putty window showing
U-Boot 1.1.5 (Apr 6 2009 - 13:54:11)
DRAM: ar7100_ddr_initial_config(237) enter!
ar7100_ddr_initial_config(269) exit!
U-Boot 1.1.5 (Apr 6 2009 - 13:54:11)
AP81 (ar7100) U-boot
sri
32 MB
WRT160NL u-boot version: 1.0.0
Top of RAM usable for U-Boot at: 82000000
Reserving 277k for U-Boot at: 81fb8000
Reserving 192k for malloc() at: 81f88000
Reserving 44 Bytes for Board Info at: 81f87fd4
Reserving 36 Bytes for Global Data at: 81f87fb0
Reserving 128k for boot params() at: 81f67fb0
Stack Pointer at: 81f67f98
Now running in RAM - U-Boot at: 81fb8000
id read 0x100000ff
flash size 8MB, sector count = 128
Flash: 8 MB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
ag7100 get ethaddr for device eth0
Fetching MAC Address from 0x81feaf20
--------***** Get the RTL8306SD Manufactory ID=34dc *****-------
Reg6: speed=0 nway=1 duplex=1
Reg5: speed=0 nway=0 duplex=0
Reg1: a1=7fd9 a2=2890 a3=115c a4=2890 a5=0
Reg1: a1=7fd9 a2=2890 a3=115c a4=2890
Reg1: a1=7fd9 a2=2890 a3=115c a4=2890
Reg1: a1=7fd9 a2=2890 a3=115c a4=2890
Reg1: a1=7fd9 a2=2890 a3=115c a4=2890
eth0: 00:23:69:f9:5a:3d
eth0 up
eth0
### main_loop entered: bootdelay=1
Hit any key to stop autoboot: 0
## Booting image at bf04003c ...
Image Name: MIPS OpenWrt Linux-2.6.30.9
Created: 2010-03-09 16:38:37 UTC
Image Type: MIPS Linux Kernel Image (gzip compressed)
Data Size: 1208402 Bytes = 1.2 MB
Load Address: 80060000
Entry Point: 80060000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
kernel: org len = 1208402, new len = 1245184
No initrd
## Transferring control to Linux (at address 80060000) ...
## Giving linux memsize in bytes, 33554432
Starting kernel ...
Linux version 2.6.30.9 (sknataraj@wolf.samknows.com) (gcc version 4.3.3 (GCC) ) #1 Tue Mar 9 16:38:26 GMT 2010
console [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR9130 rev 2, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=WRT160NL
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
NR_IRQS:56
PID hash table entries: 128 (order: 7, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 29424k/32768k available (2014k kernel code, 3344k reserved, 432k data, 136k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
net_namespace: 1008 bytes
NET: Registered protocol family 16
MIPS: machine is Linksys WRT160NL
bio: create slab <bio-0> at 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
yaffs Mar 9 2010 16:33:53 Installing.
msgmni has been set to 57
alg: No test for stdrng (krng)
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console handover: boot [early0] -> real [ttyS0]
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth1: Atheros AG71xx at 0xba000000, irq 5
Registering RTL8306SD switch with Chip ID: 0x5988, version: 0x0000
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: en25p64 (8192 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x7e0000
Searching for RedBoot partition table in spi0.0 at offset 0x7f0000
No RedBoot partition table detected in spi0.0
6 wrt160nl partitions found on MTD device spi0.0
Creating 6 MTD partitions on "spi0.0":
0x000000000000-0x000000040000 : "u-boot"
0x000000040000-0x000000180000 : "kernel"
0x000000180000-0x0000007e0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=350000, len=490000
0x000000350000-0x0000007e0000 : "rootfs_data"
0x0000007e0000-0x0000007f0000 : "nvram"
0x0000007f0000-0x000000800000 : "art"
0x000000040000-0x0000007e0000 : "firmware"
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly on device 31:2.
Freeing unused kernel memory: 136k freed
Please be patient, while OpenWrt loads ...
- preinit -
Registered led device: wrt160nl:blue:power
Registered led device: wrt160nl:amber:wps
Registered led device: wrt160nl:blue:wps
Registered led device: wrt160nl:blue:wlan
Press CTRL-C for failsafe
gpio-buttons driver version 0.1.1
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
Button Hotplug driver version 0.3.1
eth0: link up (100Mbps/Full duplex)
eth0: link down
switching to jffs2
mini_fo: using base directory: /
mini_fo: using storage directory: /jffs
- init -
Please press Enter to activate this console. eth0: link up (100Mbps/Full duplex)
device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering forwarding state
device eth1 entered promiscuous mode
cfg80211: Using static regulatory domain info
cfg80211: Regulatory domain: EU
(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
(2402000 KHz - 2482000 KHz @ 40000 KHz), (600 mBi, 2000 mBm)
(5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2000 mBm)
(5490000 KHz - 5710000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
cfg80211: Calling CRDA for country: EU
cfg80211: Calling CRDA for country: EU
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
phy0: Atheros AR9100 MAC/BB Rev:0, AR2122 RF Rev:a2, mem=0xb80c0000, irq=2
PPP generic driver version 2.4.2
NET: Registered protocol family 24
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ar71xx-ehci ar71xx-ehci: Atheros AR91xx built-in EHCI controller
ar71xx-ehci ar71xx-ehci: new USB bus registered, assigned bus number 1
ar71xx-ehci ar71xx-ehci: irq 3, io mem 0x1b000000
ar71xx-ehci ar71xx-ehci: USB 2.0 started, EHCI 1.00
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
BusyBox v1.14.4 (2010-03-09 15:49:15 GMT) built-in shell (ash)
Enter 'help' for a list of built-in commands.
_
___ __ _ _ __ ___ | | ___ __ _____ _____
/ __|/ _` | '_ ` _ \| |/ / '_ \ / _ \ \ /\ / / __|
\__ \ (_| | | | | | | <| | | | (_) \ V V /\__ \
|___/\__,_|_| |_| |_|_|\_\_| |_|\___/ \_/\_/ |___/
P E R F O R M A N C E M O N I T O R I N G
OS: OpenWRT KAMIKAZE
SW: WRT160NL Build (1.0)
-------------------------------------------------
root@OpenWrt:/#
