Hello, i'm using a guide http://wiki.openwrt.org/doc/howto/generic.uninstall for reverting back to the original firmware. I use mtd. But when i run the command "mtd -r write /tmp/WRT54G3G_2.11.05_ETSI_code.bin firmware" i receive the error: " Could not open mtd device: firmware
Can't open device for writing!"
So what should i do in order to pointing out the correct device? How could i find it out?
Thanks in advance.
Topic: Reverting back on Linksys WRT54G3G question
The content of this topic has been archived on 28 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1