Working on getting openwrt running on a linksys e1000 (same hardware as wrt160nv3, cisco valet m10). Have serial access. Wireless is working with b43 driver, wired is saying in kernel bootup
roboswitch: Probing device eth0: No such device
...and repeats this for eth1-3
Can post logs if needed.
BTW boots up and openwrt works, just wired lan is not working.
thanks.
Topic: ethernet not working on linksys e1000
The content of this topic has been archived on 16 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1