The content of this topic has been archived on 31 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hello,
I'm stuck with my WZR-HP-AG300H, cause I setup wrong parameters in interfaces (wireless and ethernet). Thus the device boots but there is no possible IP connectivity.
I tried a 30/30/30 reset but no luck, anyone knows how to manually reset the firmware to factory settings? (I suppose a tftp flash will not be usefull cause it's NVRAM corrupted...?)
Thank you
What nvram? Openwrt stores settings as files in normal flash.
Go to Openwrt failsafe mode and reset the file system from there.
http://wiki.openwrt.org/doc/howto/generic.failsafe
(see your router's wiki page & forum, if you find more exact info about the moment when to push a button during the boot.)
The discussion might have continued from here.