OpenWrt Forum Archive

Topic: TP-link WDR4300 how to reset?

The content of this topic has been archived on 23 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Good evening

I changed the settings from static IP to DHCP.
But now I cant acess the router any more. I turn the power Off an on again and when the SYS LED lights up I pushed the reset button. Now the LED is beating fast.
So I think that is the failsafe mode but how can i reset the settings now?

EDIT: installed telnet on Win 8 and i am in now but which command to reset?

I tried firstboot Hope it works

Worked! Can be closed here

(Last edited by napoisamzocken on 7 Feb 2013, 01:52)

Hey god a new problem.
How to cut the original .bin?
Because it is an "Boot" .bin.

I don't quite understand the question. Could you please give more info?

The discussion might have continued from here.