The content of this topic has been archived on 2 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Hello!
Two days ago I bought new Ubiquti NanoStation2 Loco (1234G 002722F0F9BC). Then I try to upload the OpenWrt Firmware (http://downloads.openwrt.org/backfire/1 … uashfs.bin) via web-interface, I see this error: "bad firmware update image". You can see it in the screen. How to upload OpenWrt Firmware to my NanoStation2 Loco? Please help me!
(Last edited by olegkoltakov on 13 Feb 2013, 16:00)
I just tried this same process and am getting the same error. Have you had any luck with the upgrade yet? I was thinking about purchasing ddwrt and giving that a shot...
I was able to get the image installed by using the TFTP method http://wiki.openwrt.org/toh/ubiquiti/na … installing After it reboot, I can telnet into the device, and I changed the password. I am UNABLE to access the web interface though. Any thoughts?
I am UNABLE to access the web interface though. Any thoughts?
telnet into the router, run "opkg update", then "opkg install luci". Finally, run "/etc/init.d/uhttpd start" to start the web server. The image you installed probably did not come with a web interface and these commands will install it.
For more details, check out the wiki
The discussion might have continued from here.