Hi,
yesterday I upgraded the Firmware of my TP-Link WR1043ND to openWRT,
at first all works fine, after 30-30-30 reset i can not acces Web-GUI and can not ping

I allready did what ist written  here

Can access failsafe mode & can ping router in failsafe

mtd -r erase rootfs_data 

causes

Could not open mtd device: rootfs_data
Could not open mtd device: rootfs_data

opkg update
opkg install luci
/etc/init.d/uhttpd enable
/etc/init.d/uhttpd star

causes

Collected errors:
* opkg_conf_load: Could not create lock file /var/lock/opkg.lock: No such file or directory.
root@(none):/# opkg install luci
Collected errors:
* opkg_conf_load: Could not create lock file /var/lock/opkg.lock: No such file or directory.
root@(none):/# /etc/init.d/uhttpd enable
root@(none):/# /etc/init.d/uhttpd start
bind(): Address already in use
Error: No sockets bound, unable to continue

Hope you can help

Thanks

Bodo_93

What firmware version? Not all have luci included.
After the 30-30-30 reset can you telnet 192.168.1.1 through ethernet (via Putty or whatever)?

Aktuell Version of open wrt , more details I don't know.

after 30-30-30 reset i can acces via Telnet, when router is in recovery-mode (fast blinking sys led)

edit: now I am at home, so I opened Telnet and there I can see (12.09-rc1, r34185),  maybe my version of open wrt?

firstboot causes:

firstboot has already been run
jffs2 partition is mounted, only resetting files
MTD partition not found.

Hope sombody can help.

(Last edited by bodo_93 on 17 Feb 2013, 18:57)

Nobody can help?
do you need more information that anyone can help?

did you:
mount_root
before you typed
firstboot?

please check the hardware version of your TP-Link WR1043ND which could be found at the bottom of your unit. this will help you how to do the flashing. fail safe mode is available, its link and every information could be found in the page of the unit which is at the bottom of this message. there are differences in the hardware version of this model which should be noted before flashing OpenWRT. hope this could help you.

http://wiki.openwrt.org/toh/tp-link/tl-wr1043nd

(Last edited by @ll@n416 on 8 Mar 2013, 15:23)

Also, if you flashed jffs rather than squashfs, then you might be screwed.