Hi!
I'm new to OpenWrt and this was my frist time that I put openWrt into AP.
AP is WAP54G version 3
I put openwrt-wap54g-squashfs.trx file thru web interface of orginal frimware and things gone right.
I set pass and access AP thru putty and later thru web setup where I see that channel range is 1 to 11
wich was not good for me my part of wireless network is on 12 ch, then on web I found that I can change
channel range by entering in nvram set wl_country=all and after commit i have bricked AP with non working LAN port but Wifi was working but not accessable.
I try with shorting pin 15 to ground (flash is sst 39vf1601) and that was give lan access for two times but nofting was
changed after tftp orginal frimware into AP I can just say that even more bricked.
I made seriall adapter with max232 and sucessfuli conected to console from what I see that my AP do not see any network interface. AP give not such device mesage after changing some variables in nvram AP give this on console
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.4)
Initializing Arena
Initializing Devices.
et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 3.90.39.0
CPU type 0x29008: 200MHz
Total memory: 8192 KBytes
Total memory used by CFE: 0x80300000 - 0x80399700 (628480)
Initialized Data: 0x8032F870 - 0x80331F50 (9952)
BSS Area: 0x80331F50 - 0x80333700 (6064)
Local Heap: 0x80333700 - 0x80397700 (409600)
Stack Area: 0x80397700 - 0x80399700 (8192)
Text (code) segment: 0x80300000 - 0x8032F870 (194672)
Boot area (physical): 0x0039A000 - 0x003DA000
Relocation Factor: I:00000000 - D:00000000
Device eth0: hwaddr 00-90-4C-91-00-01, ipaddr 192.168.1.245, mask 255.255.255.0
gateway not set, nameserver not set
Boot program checksum is invalid
Reading :: Failed.: Timeout occured
So I think that problem is in nvram
I stil don't get link up on lan port and can't ping it
If somebody have nvram list of this AP I wuld most aprised that kind of help.
here is my nvram
nvram show
wl_radius_port=1812
opo=12
wan_unit=0
wan_route=
wan_pppoe_keepalive=0
log_ipaddr=0.0.0.0
il0macaddr=00:90:4c:91:00:01
boardrev=0x13
et0macaddr=00:90:4c:91:00:01
wan-ifname=eth1
wl_maxassoc=128
wan_pppoe_passwd=
boot_wait=on
watchdog=1000
wl_phytypes=g
SNMPCommunityOne=public
fw_disable=0
et0mdcport=0
wl_infra=1
ses_event=2
reset_gpio=7
pmon_ver=CFE 3.91.39.0
restore_defaults=0
antenna_selection=default
wan0_ifname=eth1
wan_pppoe_service=
wan_lease=86400
ap_repeater_channel=6
wl_radius_ipaddr=
http_wanport=
lan_gateway=192.168.1.1
wl0_ifname=eth2
lan_domain=
timer_interval=3600
gpio1=ses_led
wl_net_reauth=36000
forward_port0=
vlan0ports=1 2 3 4 5*
ses_enable=1
wan_pppoe_mru=1492
lan_route=
wan_gateway=192.168.1.1
dhcp_start=192.168.1.100
wl_mrate=0
dhcp_end=192.168.1.150
wl_akm=
ses_button_pressed=1
sromrev=2
auth_mode=
FilterSwitch=0
boardtype=0x0467
is_default=1
wl_gmode=1
stats_server=
wl0_auth_type=
wl_mac_index=0
lan_netmask=255.255.255.0
SYSName=
wl_wme_sta_vi=7 15 2 6016 3008 off
http_username=
wl_wme_ap_be=15 63 3 0 0 off
os_date=Jul 22 2005
wds0=
http_lanport=80
FirmwareVersion=v3.02, Jul 22, 2005, ETSI
wds1=
wl_wme_sta_vo=3 7 2 3264 1504 off
wl_plcphdr=long
wds2=
wl_macmode=disabled
wds3=
wl_wme_ap_bk=15 1023 7 0 0 off
wan_domain=
wan_hwname=
wl_phytype=g
wan_netmask=255.255.255.0
lan_lease=86400
wl0id=0x4318
wl_lazywds=1
filter_client0=
filter_maclist=
wl_auth_mode=none
wl_wpa_psk=
http_passwd=admin
ag0=2
wan_pppoe_demand=0
lan_stp=1
chk_downgrade_hdr=Enabled
wl_mode=ap
wl_wpa_gtk_rekey=300
wl0gpio0=0
lan_dhcp=0
wl0gpio1=0
wl0gpio2=0
wl0gpio3=0
wl0gpio4=0
GTK_wl_wpa_psk=
wl0gpio5=2
d11g_rts_cts=off
wl_wds_timeout=1
lan_hwaddr=00:00:00:00:00:00
wan_dns=
wl_dtim=3
wl_ssid=linksys
wan_pppoe_mtu=1492
ap_client_wep_key=
wl_mac_hwaddr=
wl_passphrase=
dhcp_wins=wan
os_server=
wl_key1=
wan_proto=static
wl_key2=
wl_key3=
wl_key4=
wl_country_code=AU
ses_fsm_last_status=0
wl_hwaddr=
PassphraseKeyLength=2
pa0itssit=62
SNMPEnable=0
wan_pppoe_idletime=60
MyFirmwareVersion=v3.02.03(EU), Jul 22, 2005
ap_client_wep=off
ap_mode=0
wl_rate=0
ap_client_ssid=
log_level=0
cctl=0
ntp_server=192.5.41.40 192.5.41.41 133.100.9.2
SYSLocation=
lan_ifnames=vlan0
wl_country=Worldwide
pa0maxpwr=0x4e
wan_pppoe_username=
ap_client_mac=
wan_ifnames=eth1
wl_auth_type=
ses_fsm_current_states=01:01
wl_crypto=tkip
wl_rateset=default
wl_radius_key=
lan_proto=static
os_name=linux
lan_ipaddr=192.168.1.245
clkfreq=200
RWEnableTwo=0
aa0=3
wl_unit=0
router_disable=1
sdram_config=0x0062
dmz_ipaddr=
wl_wds=
SYSContact=
wl_wme=off
wl_wme_ap_vi=7 15 1 6016 3008 off
wan_primary=0
lan_ifname=br0
sdram_refresh=0x0000
dhcp_domain=wan
wl_auth=0
sdram_ncdl=0x00030028
MP_TEST_SES_BTN=0
wl_wme_ap_vo=3 7 1 3264 1504 off
wl_frameburst=on
GTK_tmp_key_index=1
ezc_enable=1
is_modified=0
wan_ipaddr=192.168.1.245
wl_ifname=
wan_wins=
wl_wep=disabled
os_version=3.91.23.0
wl_gmode_protection=auto
wl_frag=2346
RWEnableOne=0
wl_maclist=
filter_macmode=deny
et0phyaddr=32
console_loglevel=1
time_zone=PST8PDT
security_mode_page=4
wifi_ifname=eth2
wan_ifname=eth1
wl_wme_sta_be=15 1023 3 0 0 off
lastpage=1
wl_radioids=
wl_mac=
ap_client_wep_mode=open
wan_hostname=Linksys WAP54G
wl_corerev=
wl_channel=11
wl_wme_sta_bk=15 1023 7 0 0 off
wl_afterburner=off
wl_radio=1
ezc_version=2
SES_SETUP_FLAG=0
wl_rts=2346
sdram_init=0x0102
wl_ap_isolate=0
wan_desc=
lan_wins=
EnableLAN=on
lan_hwnames=et1
wl_wme_no_ack=off
SNMPCommunityTwo=private
ap_repeater_mode=stop
wl_key=1
upnp_enable=0
wan_pppoe_ac=
curpage=1
wl_closed=0
txpwr=84
autofw_port0=
log_ipaddr_1=
ap_repeater_ssid=
ap_repeater_mac=
wan_pppoe_ifname=
log_ipaddr_2=
wl_bcn=100
log_ipaddr_3=
log_ipaddr_4=0
wl_antdiv=-1
size: 3690 bytes (29078 left)
*** command status =
Soory on my bad english an on this long post
Thanks in advance