hi all, I installed whiterussian rc4 to WLI3-TX1-G54.
the system is booting, but can't detect BCM47xx ethernet controller...
because I was not able to use the telnet, the log was seen by using the serial port.
* Specification
Model: BUFFALO WLI3-TX1-G54 Ethernet Bridge Client (Japanease Model)
http://buffalo.melcoinc.co.jp/products/ … 3-tx1-g54/
Boot_wait: on
CPU: BCM4712KPB(200MHz operation 48Mhz x 4?, lot number HA0542 P11 757548 P2)
RAM: IC42S16400-7T (8MB x 2)
FLASH: TE28F320 (4MB)
PHY(Wired): IP101 (Manufacture IC+)
Wireless: 802.11g/b (BCM4320? i can't remove shield, but it seems to work)
WLI3-TX1-G54 serial port (parts side, RX not understund...)
VCC GND
o o o o
o o o o o
^
TX
(it haven't silk, and VCC is 3.3v)
this model doesn't have a switch and WAN interface, but it is low-price (6,500yen in japan).
and, WLA2-G54C might be the same circuit board
(http://buffalo.melcoinc.co.jp/products/ … wla2-g54c/).
I will build the PlayStationPortable bridge for Xlink-kai by using this.
I'm sorry by poor English.
-- on borad serial port log(ttyS0 115200/8N1) --------------------
CFE version 1.0.37 for BCM947XX (32bit,SP,LE)
Build Date: Fri Oct 22 00:01:43 JST 2004 (root@Satoh-linux)
Copyright (C) 2000,2001,2002,2003 Broadcom Corporation.
Initializing Arena.
Initializing Devices.
* Flash Info. -> manufacturer (89), device (16)
* Flash Info. -> manufacturer2 (0000), device2 (0000)
* Flash Info. -> manufacturer (89), device (16)
* Flash Info. -> manufacturer2 (0000), device2 (0000)
* Flash Info. -> manufacturer (89), device (16)
* Flash Info. -> manufacturer2 (0000), device2 (0000)
#### 50ms gpioout hold!!
et0: Broadcom BCM47xx 10/100 Mbps Ethernet Controller 3.60.9.0
* memc_config: (00048000) -> [00048540]
CPU type 0x29007: 200MHz
Total memory: 0x1000000 bytes (16MB)
Total memory used by CFE: 0x80400000 - 0x8053C7A0 (1296288)
Initialized Data: 0x80436920 - 0x80438FF0 (9936)
BSS Area: 0x80438FF0 - 0x8043A7A0 (6064)
Local Heap: 0x8043A7A0 - 0x8053A7A0 (1048576)
Stack Area: 0x8053A7A0 - 0x8053C7A0 (8192)
Text (code) segment: 0x80400000 - 0x80436920 (223520)
Boot area (physical): 0x0053D000 - 0x0057D000
Relocation Factor: I:00000000 - D:00000000
Device eth0: hwaddr 00-0D-0B-XX-XX-XX, ipaddr 192.168.1.10, mask 255.255.255.0
gateway not set, nameserver not set
Reading :: et0: link up (interface up)
Done. 1544192 bytes read
Programming...done. 1544192 bytes written
Loader:raw Filesys:raw Dev:flash0.os File: Options:(null)
Loading: .. 3704 bytes read
Entry at 0x80001000
Closing network.
et0: link down (interface down)
Starting program at 0x80001000
CPU revision is: 00029007
Primary instruction cache 8kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 4kB, 2-way, linesize 16 bytes.
Linux version 2.4.30 (wbx@ux-2y02) (gcc version 3.4.4) #1 Wed Nov 23 22:35:53 CET 2005
Setting the PFC value as 0x15
Determined physical RAM map:
memory: 01000000 @ 00000000 (usable)
On node 0 totalpages: 4096
zone(0): 4096 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/pre
init noinitrd console=ttyS0,115200
CPU: BCM4712 rev 1 at 200 MHz
Using 100.000 MHz high precision timer.
Calibrating delay loop... 199.47 BogoMIPS
Memory: 14296k/16384k available (1395k kernel code, 2088k reserved, 100k data, 8
0k init, 0k highmem)
Dentry cache hash table entries: 2048 (order: 2, 16384 bytes)
Inode cache hash table entries: 1024 (order: 1, 8192 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 1024 (order: 0, 4096 bytes)
Page-cache hash table entries: 4096 (order: 2, 16384 bytes)
Checking for 'wait' instruction... unavailable.
POSIX conformance testing by UNIFIX
PCI: Fixing up bus 0
PCI: Fixing up bridge
PCI: Fixing up bus 1
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB.
Squashfs 2.1-r2 (released 2004/12/15) (C) 2002-2004 Phillip Lougher
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI en
abled
ttyS00 at 0xb8000300 (irq = 3) is a 16550A
ttyS01 at 0xb8000400 (irq = 0) is a 16550A
Software Watchdog Timer: 0.05, timer margin: 60 sec
cfi_cmdset_0001: Erase suspend on write enabled
Using buffer write method
Flash device: 0x400000 at 0x1c000000
Creating 5 MTD partitions on "Physically mapped flash":
0x00000000-0x00040000 : "pmon"
0x00040000-0x003e0000 : "linux"
0x000baa08-0x001b9000 : "rootfs"
mtd: partition "rootfs" doesn't start on an erase block boundary -- force read-only
0x003e0000-0x00400000 : "nvram"
0x001c0000-0x003e0000 : "OpenWrt"
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 1024 bind 2048)
ip_conntrack version 2.1 (5953 buckets, 5953 max) - 320 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
NET4: Ethernet Bridge 008 for NET4.0
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 80k freed
Algorithmics/MIPS FPU Emulator v1.5
Using /lib/modules/2.4.30/diag.o
diag boardtype: 00000101
Unlocking OpenWrt ...
Erasing OpenWrt ...
Partition marked as clean
Unlocking OpenWrt ...
mount: Mounting none on /proc failed: Device or resource busy
mount: Mounting none on /dev failed: Device or resource busy
umount: /rom/proc: No such file or directory
umount: /rom/dev: No such file or directory
init started: BusyBox v1.00 (2005.11.23-21:46+0000) multi-call binary
Please press Enter to activate this console. jffs2.bbc: SIZE compression mode activated.
eth0: Broadcom BCM4320 802.11 Wireless Controller 3.90.37.0
device eth0 entered promiscuous mode
--------------------------------------------------------------------