OpenWrt Forum Archive

Topic: Problems with WRT54GL V1.1

The content of this topic has been archived on 7 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
Selfarian
5 Jun 2013, 14:54

Hello,

i hope, this would be the right forum.

I tried to install openwrt on my WRT54GL, but first, i failed with 10.03 (unusable WebUI). So i downgraded to this one, described in the wiki:
http://downloads.openwrt.org/kamikaze/8 … uashfs.trx

Now the webui works, but i cannot connect to the internet. I set PPOE. I got the following messages in the Syslog:
[with DSL-Modem]

Feb  6 04:18:12 Born daemon.notice pppd[808]: Connect: ppp0 <--> eth0.1
Feb  6 04:18:12 Born daemon.warn pppd[808]: Couldn't increase MTU to 1500
Feb  6 04:18:12 Born daemon.warn pppd[808]: Couldn't increase MRU to 1500
Feb  6 04:18:13 Born daemon.info pppd[808]: CHAP authentication failed: Request Denied
Feb  6 04:18:13 Born daemon.warn pppd[808]: Couldn't increase MTU to 1500
Feb  6 04:18:13 Born daemon.warn pppd[808]: Couldn't increase MRU to 1500
Feb  6 04:18:13 Born daemon.notice pppd[808]: Connection terminated.

[without DSL-Modem]

Feb  6 04:18:58 Born daemon.warn pppd[808]: Timeout waiting for PADO packets
Feb  6 04:18:58 Born daemon.err pppd[808]: Unable to complete PPPoE Discovery

I also was unsure if ppoe is correct, but i checket it on my working fritzbox and there is ppoe set and working - but the fritzbox has an integrated dsl-modem...

Could anyone help me?

Thanks and best regards,

Alex

(Last edited by Selfarian on 7 Jun 2013, 11:05)

Post #2
Selfarian
7 Jun 2013, 11:05

Has no one an idea?...

The discussion might have continued from here.