http://sourceforge.net/projects/officia … z/download
don't know if it works or not but should be able to compile it
Topic: OpenWRT for D-Link dir-655
The content of this topic has been archived on 24 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Is there a compiled version of this somewhere? I don't mind trying it out and possibly bricking my router.
keen wrote:
Is there a compiled version of this somewhere? I don't mind trying it out and possibly bricking my router.
What hardware version is your router?
I have version B
keen wrote:
I have version B
I had to make a new build environment since the source is a little on the old side. Here is an initial sanity check build in which all options should be default. I'm working on getting a build with a shell enabled right now.
http://sourceforge.net/projects/routert … n/download
Here's a build where telnet should be enabled, file came out around the same size but it's probably just a config option to enable telnet as the router does come with busybox on stock http://sourceforge.net/projects/routert … n/download try the other one first to make sure these are being built correctly then flash this after and try to connect with a telnet client.
Lightsword wrote:
keen wrote:I have version B
I had to make a new build environment since the source is a little on the old side. Here is an initial sanity check build in which all options should be default. I'm working on getting a build with a shell enabled right now.
http://sourceforge.net/projects/routert … n/download
It uploaded successfully... however, it caused my router to go straight to ROUTER RECOVERY MODE.
Fortunately, I was expecting this, so had the original firmware ready.
D-Link DIR-655, REV B1, FIRMWARE REV 2.11NA
Is there any update for the Dir-655, I have try to update these two firmware. Seems it is the D-link offical Firmware.
I'm also have two Dir-655, one is B1, and one is A4.
How to flash this firmware? Or just upload it in D-link firmware webpage?
The D-link original firmwares crashe very often. It almost drives me crazy.
My device is D-Link DIR-655, REV B1, FIRMWARE REV 2.09NAb013
(Last edited by jiunnhui on 3 Apr 2015, 03:33)
NemesiS2015 is trying to install re-compiled firmware, but Dir-655 can't fully boot?
https://forum.openwrt.org/viewtopic.php?id=57498
Lightsword wrote:
Here's a build where telnet should be enabled, file came out around the same size but it's probably just a config option to enable telnet as the router does come with busybox on stock http://sourceforge.net/projects/routert … n/download try the other one first to make sure these are being built correctly then flash this after and try to connect with a telnet client.
How do I flash this firmware?
Do I just upload the .bin file on D-link FIRMWARE UPGRADE webpage?
(Last edited by crazy-mikey on 1 Aug 2015, 18:10)
The discussion might have continued from here.
Page 1 of 1