I want to use openwrt at tp-link tl-wvr450g.
Can you support this device?
Hardware info
Atheros AR-9344 mips32 560 Mhz CPU.
Atheros 9381-AL1A - wireless
Atheros AR8327N-AL1A lan/wan
1 console port
128mb(1Gbit) ddr-II ram - Hynix-HYNH5PS5162GFRY5C -DRAM Chip DDR2 SDRAM 512M-Bit 32Mx16 1.8V 84-Pin FBGA * 2
16Mbyte flash - SPANSION - FL 128SAIFOO
-------------------------------------------------------------------------------------------------------------------------------------------------------
TP-LINK > en
Enter password:
TP-LINK # sys reboot
This command will reboot system, Continue? [Y/N]: y
Copyright(C) 2001-2012 by TP-LINK TECHNOLOGIES CO., LTD.
________ ________ __ __ ____ _ __ ___
|________|| ___ | | | | || \ | || | / /
| | | |___| | __ __ | | | || \| || |/ /
| | | _____| |__ __| | |___ | || |\ || \
|__| |__| |______||__||_| \____||__|\___\
Software Platform for MIPS
U-Boot 1.1.4 (Jul 4 2012 - 09:32:32)
Autobooting in 1 seconds
ar9344> printenv
bootargs=console=ttyS0,115200 root=31:02 rootfstype=jffs2 init=/sbin/init mtdparts=ath-nor0:256k(u-boot),64k(u-boot-env),6336k(rootfs),1408k(uImage),64k(mib0),64k(ART)
bootcmd=calibrate normal;go 0x9f040000
bootdelay=1
baudrate=115200
ethaddr=0x00:0xaa:0xbb:0xcc:0xdd:0xee
ipaddr=192.168.1.10
serverip=192.168.1.27
dir=
lu=tftp 0x80060000 ${dir}u-boot.bin&&erase 0x9f000000 +$filesize&&cp.b $fileaddr 0x9f000000 $filesize
lf=tftp 0x80060000 ${dir}db12x${bc}-jffs2&&erase 0x9f050000 +0x630000&&cp.b $fileaddr 0x9f050000 $filesize
lk=tftp 0x80060000 ${dir}vmlinux${bc}.lzma.uImage&&erase 0x9f680000 +$filesize&&cp.b $fileaddr 0x9f680000 $filesize
stdin=serial
stdout=serial
stderr=serial
ethact=eth0
Environment size: 698/65532 bytes
----------------------------------------------------------------------------------------------------------------------------
(Last edited by remzi.akyuz on 1 Oct 2013, 15:03)