I tried to install openwrt on my tp-link tl-WR703N, it seems I made a mistake in the step of configuring network settings. Now I'm stuck, the tp-link is not responding
Is there a trick to remedy this
Topic: TP-LINK blocked after configuring network settings
The content of this topic has been archived on 5 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
So, have you seen the router at 192.168.1.1 since you flashed it with OpenWrt? Is it still there? If it was and you have edited the network settings and now lost it, then you have two options.
Plan A is to search for it using netscan, remembering that you must have a network card on the same subnet as netscan is searching. It might take a long time, especially if you have screwed up the subnet rather than the IP address.
Plan B is to treat as a 'bricked' router and solder a serial to USB adapter on, get the instructions by googling 'bricked wr703n'. This might take even longer if your soldering skills are not up to it and you might finish up with a dead router.
Best of luck,
John
http://wiki.openwrt.org/doc/howto/generic.failsafe
http://wiki.openwrt.org/toh/tp-link/tl- … lsafe.mode
(Last edited by drawz on 9 Mar 2014, 06:28)
The discussion might have continued from here.
Page 1 of 1