The content of this topic has been archived on 11 Mar 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
This has probably been asked before, is there a command that will switch to lock into the strongest signal instead of any signal? Or a command that will show you a list of all available signals? I am talking about cli
(Last edited by hytecman on 21 Mar 2014, 19:17)
List of available signals: http://wireless.kernel.org/en/users/Doc … w#Scanning
Since the router is normally acting as a server for wireless clients (and usually not moving), I don't really see the point in doing so, and thus a low chance of finding this in openwrt.
Thanks a lot, this helps. Actually, these are repeaters on an entire WiFi network and the repeater/router seems to just jump from signal to signal, but not to locking onto a strong signal, like there is a bug in the software. Want to tell the repeater/router to lock onto the strongest signal it finds after scanning the available signals.
(Last edited by hytecman on 21 Mar 2014, 20:46)
The discussion might have continued from here.