HI
I flash my wr710 and I can connect to internet, update opkg, install opkg etc.....
Problem arise after I enable wifi and configure as client.
So I activate failsafe and do same procedure as above.
This time, there is no internet access. I can ping the router, but home router cannot detect wr710 ip address.
When I check home router, I come to know that home router detect other ip address rather than wr710's.
I think that is the reason that router has no access to intenet.
I tried two times with failsafe. No luck.
Any solution, please?
Topic: Home Router cannot detect WR710n IP Address
The content of this topic has been archived on 17 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Hi
Now I can manage to get home router see wr710 ip address.
I can ping ip address.
I still cannot update opkg.
Any suggestion,please?
Hi
Good news.
Now I can connect to internet and run opkg.
I don't do anything, just reboot and reboot......
http://wiki.openwrt.org/doc/recipes/routedclient
check that lan and wan ip are on different subnets..
maybe post your config (network and wireless)
The discussion might have continued from here.
Page 1 of 1