Hi i've acquired the above router that was used on samknows. I would like to flash openWrt to it but havent a clue where to begin, can anyone give me a dummies guide to do it.
Topic: tp link wdr3600 v1.5
The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Thanks, I saw that before i created this thread but i haven't a clue what to do. I was going to try go back to stock but the bit about cutting the .bin has me lost altogether.
trucker wrote:
Hi i've acquired the above router that was used on samknows. I would like to flash openWrt to it but havent a clue where to begin, can anyone give me a dummies guide to do it.
trucker wrote:
Thanks, I saw that before i created this thread but i haven't a clue what to do. I was going to try go back to stock but the bit about cutting the .bin has me lost altogether.
What do you want to do, exactly? To install OpenWRT? Or you already installed it and want to revert to the stock firmware?
(Otherwise, such questions should better be asked in "general discussion" section, not "hardware hacking".)
Sorry wasn't sure where to post. As it it there is a version of openWRT on it that just takes measurements. If like to use it as a router and don't mind if it's stock or openWRT but whatever is easier to do.
The discussion might have continued from here.
Page 1 of 1