Hi to all !

I recently purchasesd this traveler router TP-Link 703N, and because they arrive to me with chinese interface i flashed with MR-3020 FW to get English WEB UI. After that, i flashed my 703N with OpenWRT for MR-3020 and router works good, but LED not works.. How to enable LED to works.?

Images from my combination..

Flash wr703n firmware..

How to flash.? Any tutorial, how to flash.? I`m newbie here I dont have also serial cable.. Any way to flash, without soldering.?
Can i flash direct from OpenWRT WEB UI, or must flash via telnet to avoid bricking on the router?

Also i want to ask, is possible this:

From OpenWRT go to stock FW for MR-3020. Then flash to DDWRT, and then revert to chinese FW for 703N (DDWRT have webrevert files for almost every router supported by DDWRT). After reverting to CH FW, flash again OpenWRT, but now with .bin for 703N, not for 3020 as first time.? I think that, will not have problem, because, MR-3020 and 703N have basically the same hardware. Suggestion?

(Last edited by deanMKD on 4 Oct 2014, 01:00)

Just use sysupgrade!

http://wiki.openwrt.org/doc/howto/generic.sysupgrade

with the 703 image
You will need the --force parameter since it will complain about hwid mismatch...

Tried to flash with original factory FW from 703N but..

Help.?

i guess you did not read the page i linked to...

anyway use openwrt image for 703!

Ah... I will try now.

So i need to use squashfs-factory.bin or squashfs-sysupgrade.bin firmware for 703N ?

EDIT: Tryed to flash with sysupgrade.bin for 703N, but the same error posted before show me..

I used this file to flash.

http://downloads.openwrt.org/attitude_a … pgrade.bin

(Last edited by deanMKD on 4 Oct 2014, 15:02)

Finally !!

Tnx nebbia88 for your help.