Topic: Set two WR-1043ND V2 as Root AP and Wireless Repeater.

The content of this topic has been archived on 30 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

Dekken

7 Oct 2014, 17:36

Hi,

I have been googling for a while now, tried the 1043ND repeater guide and searched all over and I seem to mess up every time.

I currently have one WR-1043ND V2 with a stock firmware acting as the main router, it broadcasts wireless.
And I also have a WR-1043ND V2 with the latest OpenWRT installed with the GUI.

Can someone point me in the right direction to have the OpenWRT router act as a normal wireless repeater, so it wont have to be attached to any ethernet cables?

Thanks!

The discussion might have continued from here.

Page 1 of 1