Greetings,

I have a WRAP 1e with CM9 installed. It was working fine as a client, but I decided to get rid of the cables and to install another wifi card - CM11. So to be able to make a wireless relay.
When I installed the new card it started to work, but the old one stopped:

[    9.849179] ath5k 0000:00:0d.0: registered as 'phy0'
[    9.870962] ath5k: phy0: POST Failed !!!
[    9.883165] ath5k: probe of 0000:00:0d.0 failed with error -11
[    9.901529] ath5k 0000:00:11.0: registered as 'phy1'
[   10.680466] ath: EEPROM regdomain: 0x0
[   10.680512] ath: EEPROM indicates default country code should be used
[   10.680553] ath: doing EEPROM country->regdmn map search
[   10.680608] ath: country maps to regdmn code: 0x3a
[   10.680647] ath: Country alpha2 being used: US
[   10.680682] ath: Regpair used: 0x3a
[   10.682417] ieee80211 phy1: Selected rate control algorithm 'minstrel_ht'
[   10.686610] ath5k: phy1: Atheros AR5414 chip found (MAC: 0xa5, PHY: 0x61)

PCI bus found both cards:

00:0d.0 Ethernet controller: Atheros Communications Inc. AR5212/AR5213 Wireless Network Adapter (rev 01)
00:11.0 Ethernet controller: Atheros Communications Inc. AR5413/AR5414 Wireless Network Adapter [AR5006X(S) 802.11abg] (rev 01)

Any help is welcome!