The content of this topic has been archived on 7 May 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Download https://downloads.openwrt.org/barrier_b … 64.tar.bz2
untar
make image
Collected errors:
* opkg_install_cmd: Cannot install package brcm2708-gpu-fw.
Its not in packages nor is it in the pre-built packages at https://downloads.openwrt.org/barrier_b … /packages/
If it has to be manually built and added... from where?
(Last edited by adamm on 23 Oct 2014, 02:35)
Makefile is here https://dev.openwrt.org/browser/trunk/p … w/Makefile
Build it with the SDK
copy the two folders out of the build_dir/target... folder into the ImageBuilder build_dir/target.... folder
The discussion might have continued from here.