I have a Fiberhome AN1020-25U ADSL+3G Modem. My modem is bricked...! Modem's ip 192.168.1.1 is also not responding. Then I tried serial line recovery, I connected all wires (Rx, Tx etc) correctly. And connect my modem to PC using Serial port: http://1drv.ms/1B2FW0p

Then I opened hyperterminal and set COM1 port(for my pc) and other default settings. Then I Switched ON my modem. BUT...!!!!

I did not see any line like "Autobooting in 1 sec", etc.

I only saw this data is displayed every time I ON my router: http://1drv.ms/1x7XCrl

I want to clear NVRAM and update firmeare But I can't access to CFE> mode...!
I tries Ctrl-C also during power on of modem.But can't.... please Help me...!!!

(Last edited by keylooger55 on 23 Dec 2014, 20:07)