Topic: MMC Card on Buffalo WBR2-G54

The content of this topic has been archived on 21 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

Abzstrak

27 Apr 2006, 01:22

ok I found out about this openwrt a few days ago, and have become mod happy ;-)

so I have located 4 GPIO's, soldered them and then modded the mmc.c accordingly, compiled and insmod'd it. I get the following error:

mmc Hardware init
mmc Card init
mmc Card init
mmc: error in mmc_card_init (1)
mmc: error in mmc_init (-1)

I'm having a bit of trouble tracking down the cause, anyone else whos tried something similar that can lend a hand?

TIA

The discussion might have continued from here.

Page 1 of 1