This is the error on boot up. I'm new at this and would appreciate any help. Thanks in advance
------
[ 15.840000] rt2800_wmac 10180000.wmac: failed to load eeprom property
[ 15.860000] ieee80211 phy0: rt2x00lib_request_eeprom_file: Info - Loading EEPROM data from 'soc_wmac.eeprom'.
[ 15.880000] rt2800_wmac 10180000.wmac: Direct firmware load for soc_wmac.eeprom failed with error -2
[ 15.900000] rt2800_wmac 10180000.wmac: Falling back to user helper
[ 15.940000] firmware soc_wmac.eeprom: firmware_loading_store: map pages failed
[ 15.960000] ieee80211 phy0: rt2x00lib_request_eeprom_file: Error - Failed to request EEPROM.
[ 15.970000] rt2800_wmac: probe of 10180000.wmac failed with error -11
[ 23.610000] 8021q: adding VLAN 0 to HW filter on device eth0
---------
Below is my board information:
root@OpenWrt:/# cat /proc/cpuinfo
system type : Ralink MT7620A ver:2 eco:6
machine : Ralink MT7620a + MT7610e evaluation board
processor : 0
cpu model : MIPS 24KEc V5.0
BogoMIPS : 385.84
wait instruction : yes
microsecond timers : yes
tlb_entries : 32
extra interrupt vector : yes
hardware watchpoint : yes, count: 4, address/irw mask: [0x0ffc, 0x0ffc, 0x0ffb, 0x0ffb]
isa : mips1 mips2 mips32r1 mips32r2
ASEs implemented : mips16 dsp
shadow register sets : 1
kscratch registers : 0
package : 0
core : 0
VCED exceptions : not available
VCEI exceptions : not available
root@OpenWrt:/# cat /proc/mtd
dev: size erasesize name
mtd0: 00030000 00010000 "u-boot"
mtd1: 00010000 00010000 "u-boot-env"
mtd2: 00010000 00010000 "factory"
mtd3: 007b0000 00010000 "firmware"
mtd4: 00125e0f 00010000 "kernel"
mtd5: 0068a1f1 00010000 "rootfs"
mtd6: 00480000 00010000 "rootfs_data"
root@OpenWrt:/# cat /tmp/sysinfo/board_name
generic
root@OpenWrt:/# cat /tmp/sysinfo/model
Ralink MT7620a + MT7610e evaluation board