Hi I was wondering if there is a more in depth tutorial on how to install openwrt than what is up on the openwrt. Do i just need to solder a 4 pin serial to jtag pin out holes? Can I use an Arduino to flash it?
Thanks
Ben
Topic: BT HomeHub 2.0 Type A quick question.
The content of this topic has been archived on 18 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Hello, I do not have a BT HH, but I have a very similar device. And you need an old-skool 25 pin Parallel Port for the suggested program to work. dont connect a serial port, because that it very different and might cause a little damage.
If you can make your Arduino to act like a Parallel Port? then you are in-luck. (I dont own a Arduino)
The discussion might have continued from here.
Page 1 of 1