Topic: Can-utils trying to send message to LS CAN instead of HS CAN.

The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Page 1 of 1

Post #1

21 Mar 2016, 17:25

Hi all,

I am using the can-utils on my imx6 processor that is running openWRT. When I send a CAN message using the "cansend can0 xxxx" message, they always get sent on the high speed CAN bus, and not the low. Is there a way to change where the message is sent? Any advice or feedback is greatly appreciated!

Thanks,
KP

The discussion might have continued from here.

Page 1 of 1