Hello everyone.

This device is not still supported by OpenWRT. Maybe it is not so common but its hardware may work with Openwrt. It has 128 mb nand, 1 usb port.

I managed to conect to the serial console, 115200 8 n 1.

If you press the reset button while powering it on, appears an option to upload an update from 192.168.1.100

TFTP from server 192.168.1.100; our IP address is 192.168.1.1
Filename 'upgrade.bin'
Load address: 0x2000000
Loading: T T T T

maybe someone has already diescovered this. maybe not. I am up to any further steps to support this device.

It sounds supportable. https://wiki.openwrt.org/toh/hwdata/zte … xhnf660_23

The first steps are to collect as much detail about it as possible. Open it up take some photos, identify the chips and the serial connector (sounds like you have already). Links to factory images (binaries), GPL source code (if any). Capture a full boot log. You can take a look at what I went through to try and support another device (EVG2000) https://forum.openwrt.org/viewtopic.php?id=63950

(Last edited by Xotic750 on 14 May 2016, 15:10)

thanks xotic ! i am going to gather some more data for this device. Checking on internet i found russians have done work on this. they run stuff on chrooted environments but not openwrt

I have plenty of F660's available in various hardware and firmware versions.  Also have plenty of its successor; the F609.

Let me know if I can help.  I don't mind bricking a couple in the process.  I could also ship some if needed.

Telnet details

user: root
password: Zte521

source: http://4pda.ru/forum/index.php?showtopi … amp;st=100

I tested them and i can establish a telnet session. Which info should we extract now that we can use telnet?. The device itself already runs on linux.

thanks!
I have console access but can't send any command to it. Am i missing any extra config?

U-Boot 2009.08 (10月 31 2013 - 02:54:12)

Board: ZTE-88F6560-FXXX
SoC:   88F6560 A0
CPU:   Marvell Feroceon (Rev 1) - LE
       CPU @ 1000Mhz, L2 @ 400Mhz
       DDR3 @ 400Mhz, TClock @ 200Mhz
DRAM: 128 MB
NAND: 1bit HM ECC, Size: 128 MiB
In:    serial
Out:   serial
Err:   serial
Net:  egiga0 [PRIME], egiga1

Hit 1 to upgrade softwate version
Hit enter to stop autoboot:  0
yaOsFdgLgLj%kJl

the last time is what i tried to type, you press a key and it sends random characters.