Hi all,

I received a DIR-615 D4. Set up for access point second router, but after a few hours it stopped.

After checking, both green and orange power light is on when it tries to start; cannot reset, cannot go to f upgrade screen. Checked the power IC's, one has 3,3V output, one 1,5V. Is this normal?

On the serial connector, 3,3V is OK. No serial output when i try to boot it.

(I know that it is a hardware fault, but need ideas about what i need to replace on the board...)

Does anyone know what can cause an error like this?

Any help will be appreciated.

(Last edited by colt2x on 10 Sep 2016, 19:23)