Hello all,
I need a little help getting started with OpenWrt. I have been playing with DD-Wrt for a while now but my Asus RT-N56U was not supported on DD-Wrt. I decided to take a jump into OpenWrt for a little challenge and I am stuck. Here is the pre-story:
I have three routers. (1) A Netgear wndr3700 (2) a Linsys Wrt54GS and the (3) Asus Rt-N56U. The wndr3700 is my main router. It does dhcp, controls two guest networks (Adult and kids), does access restrictions, and runs a VPN, all very successfully. Within the last week, I made up my mind to stop having ump-teen wireless SSIDs in my house and start meshing them so people could roam through out the house and get the best WiFi signal. Pretty easy with DD-WRT. I am having a tough time with OpenWrt, mostly because it is new. Anyway, here is the rest of the story.
Both the adult and kid guest network have a G and 5G SSID. The kids get issued IPs in the range of 192.168.2.100 through 105 and the adults get an IP range of 192.168.3.100 through 105, mostly so I can control internet access on the kids section.
Here is what I have done so far in OpenWrt.
(1) successfully created all the SSIDs and their encrypiton. I created a bridge (br1) for the kids and (br2) for the adults. I linked each bridge their respective G and 5G SSIDs as well as eth0. I can see the SSIDs, enter a password, but the won't connect as they can get a valid IP from the wndr3700.
What am I doing wrong?
Any help would be greatly appreciated.
In DD-WRT I needed to add some extra settings using DNSMasq which I tried here with no joy. I did try and follow the Wide area Wi-Fi coverage Wiki but didn't get anywhere. I also downloaded an SSH program and cant figure out how to do anything with it.
I know I sound like I am over my head and I probably am but I always figure it out. Just need a little shove in the right direction :-)
TIA,
Dan
