Hello everyone. I tried to install OpenWRT on my brand new router and it went wrong. I updated the UI of the original system. Here is the u-boot log:
U-Boot 1.1.3 (Oct 11 2016 - 08:49:28)
Board: Ralink APSoC DRAM: 64 MB
relocate_code Pointer at: 83fb8000
******************************
Software System Reset Occurred
******************************
gpiomode2 05540554.
gpiomode2 00000000.
gpiomode2 05550555.
flash manufacture id: ef, device id 40 17
find flash: W25Q64BV
============================================
Ralink UBoot Version: 4.3.0.0
--------------------------------------------
ASIC 7628_MP (Port5<->None)
DRAM component: 512 Mbits DDR, width 16
DRAM bus: 16 bit
Total memory: 64 MBytes
Flash component: SPI Flash
Date:Oct 11 2016 Time:08:49:28
============================================
icache: sets:512, ways:4, linesz:32 ,total:65536
dcache: sets:256, ways:4, linesz:32 ,total:32768
##### The CPU freq = 575 MHZ ####
estimate memory size =64 Mbytes
RESET MT7628 PHY!!!!!!
continue to starting system. 0
disable switch phyport...
3: System Boot system code via Flash.(0xbc020000)
do_bootm:argc=2, addr=0xbc020000
## Booting image at bc020000 ...
Uncompressing Kernel Image ... LZMA ERROR 1 - must RESET board to recover
[04020C0E][04020D08]
DDR Calibration DQS reg = 00008988
And when I try to put a firmware via TFTP gives this (even being the original firmware):
TIMEOUT_COUNT=10,Load address: 0x80060000
Loading: T checksum bad
A cordial hugs to all.