Hi all

I have a NetGear N150 (WNR1000v3)

I found the firmware on the OpenWRT page and installed it via my router login page I was given a message saying this will take 1.5 minutes do not disturb it. I went out the room and came back and my browser was showing a could not connect message and now the router power led is oange and cannot connect for wifi or ethernet. What has happened and how can I fix this.

Thanks for all the help, I'm new to this so maybe should have researched it a bit more before going ahead.

Which version of OpenWRT did you install?

This is the link to the file

/trunk/brcm47xx/mips74k/openwrt-brcm47xx-mips74k-netgear-wnr1000-v3-squashfs.chk

(couldn't post full link)

What is the current ip address of you pc?

Hi my ip address is 77.100.14.86

I have had to switch to an old router just to be able to come online, do you know what I need to do? If you need more info let me know i will provide it all.

Thanks