I am experimenting with openwrt, and tried it on an old Linksys router. Everything appeared to have loaded appropriately, it even finished with the linksys screen saying that the update was successful. However, the root page is inaccessible. I can ping it from the command line, and ip config confirms gateway to be 192.168.1.1. But it will not load on any of my browser's. I did also confirm that I loaded the right firmware , in the right version. What am I doing wrong?
Topic: Wrt610n v2 fail
The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
Most probably you have installed a snapshot image, which do not come with LuCI preinstalled.
You have to install it yourself after flashing.
Thank you very much for your response. Okay,...deeper into this rabbit hole we'll go. Thanks again.
The discussion might have continued from here.
Page 1 of 1