OpenWrt Forum Archive

Topic: 1900ACSv1 on davidc502 LEDE recovery/password reset

The content of this topic has been archived on 29 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
konjiki7
10 Nov 2017, 18:52

Hey I'm a noob to OpenWrt I have been running it for 3 months now.

I set a password for luci and setup ssh configure wifi connections etc...

Tried to access the router today... Will not connect to luci and cannot reach it using putty ssh connection...

Tried to switch to the back up firmware following the openwrt instructions... with no luck not sure if there is some specific methodology to this model...

Trying to figure out how to reset it ... any help would be most appreciated...

(Last edited by konjiki7 on 10 Nov 2017, 18:56)

Post #2
davidc502
10 Nov 2017, 23:22
konjiki7 wrote:

Hey I'm a noob to OpenWrt I have been running it for 3 months now.

I set a password for luci and setup ssh configure wifi connections etc...

Tried to access the router today... Will not connect to luci and cannot reach it using putty ssh connection...

Tried to switch to the back up firmware following the openwrt instructions... with no luck not sure if there is some specific methodology to this model...

Trying to figure out how to reset it ... any help would be most appreciated...

If there is no access to luci or ssh the best method is the power on/off method.

You can use these instructions, but instead of waiting 2 seconds wait 5 seconds, and see if it doesn't work.

The discussion might have continued from here.