Hi, I am using OpenWrt with WPQ864, and I have a problem with scanning. There are stll showing a "Sending SCAN START cmd", and I can see a lot of notifications e.g. FWLOG [xxxx] WAL channel change freq=x, mode=1, flags=0 rx_ok=1 tx_ok=1. I can stop it. Can you help me? I am starting with Open Wrt, so I have no idea.
Thanks in advance!
Topic: How to stop scanning?
The content of this topic has been archived on 21 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1