OpenWrt Forum Archive

Topic: no access to router interface after install openwrt tp-link archer c25

The content of this topic has been archived on 9 Apr 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.

Post #1
lotfinoluffy
13 Jan 2018, 17:03

hi everyone

I saw couple videos on how to install the openwrt/lede on the router, downloaded the files from the site, but the minute I installed the factory bin on the archer c25, it rebooted but after that no access to the interface, tried ssh to it from a Mac and a pc, wifi is disabled.

in putty I get a timeout error, and in the terminal theres no response

the archer c25 was connected to the fiber router and served as an access point, sharing the signal via ETH, the interface was accessible from the tplinkwifi.net

but theres no wifi, router, access to anything for

thanks for you help smile

Post #2
tapper
13 Jan 2018, 18:06

what file did you install? Did you try 192.168.1.1 Was it a snapshot or LEDE 17.1.4?

The discussion might have continued from here.