Hi,
I'm new to OperWrt packages and started using the firewall-2017-11-07-c4309372.tar.xz from sources.openwrt.org. i have cross compiled the package for mips-linux and loaded the binary on to my router, but when i started it, iptable rules were not formed with following warning..
[root@DPU504G_BCM380 config]# firewall3 start
* Populating IPv4 filter table
* Zone 'lan'
* Zone 'wan'
* Rule 'Allow-Ping'
* Rule 'Allow-DHCP-Renew'
* Rule 'Allow-IGMP'
* Forward 'lan' -> 'wan'
Warning: iptc_commit(): No chain/target/match by that name
* Populating IPv4 mangle table
* Zone 'lan'
* Zone 'wan'
Warning: iptc_commit(): No chain/target/match by that name
* Set tcp_ecn to off
* Set tcp_syncookies to on
! Unable to write value: No such file or directory
* Set tcp_window_scaling to on
can someone give me any suggestions to resolve this issue..
Topic: Not able to populate the iptable rules using firewall3 start
The content of this topic has been archived on 26 Feb 2018. There are no obvious gaps in this topic, but there may still be some posts missing at the end.
Page 1 of 1
The discussion might have continued from here.
Page 1 of 1